FRITSCH PULVERISETTE 9 - Manual (Page 18)

Seite 17
TABLET PRESS
5. Clamp the pressing tool by screwing the spindle (4) down. The threaded
spindle (4) presses onto the pressing tool plunger (10).
6. Close the door.
7. Move the lever (1) backwards and forwards
 the pressure cylinder piston
(6) will be "pumped" upwards. After around 20 strokes, a pressure buildup
will be visible on the pressure gauge (7). Continue pumping until the
necessary pressure has been built up. The pressure level is dependent on
the material and must be determined during trials. The standard pressure
is around 250 bar.
8.
CAUTION Crushing Danger!
Do not place your finger between the threaded spindle and
the pressing tool.