Hangar 9 Piper Pawnee 40 ARF - Manual (Page 19)

19
ooo Step 11
Pass the servo extension through the wing and into the
bay for the flap servo. Use four #2 x 3/8-inch sheet metal
screws to attach the servo cover to the wing.
ooo Step 12
Continue to pass the aileron extension through the wing.
Use tape (or glue) to secure the aileron extension to
the top sheeting of the wing. This will prevent it from
interfering with the operation of the flap servo.
ooo Step 13
Use a pin drill and 5/64-inch (2mm) drill bit to enlarge
the outermost hole in the servo arm to accept the
pushrod wire.
ooo Step 14
Slide one of the pre-bent 3 3 /
4
-inch (95mm) linkages into
the hole drilled in the previous step.
Section 2: Aileron and Flap Servo Installation