Hangar 9 Piper Pawnee 40 ARF - Manual (Page 44)

44
 Step 6
Secure the speed controller to the bottom of the fuselage
using hook and loop tape as shown. Secure the wires
between the motor and speed control so they do not
interfere with the operation of the motor.
 Step 7
Secure the motor battery inside the fuselage using the
two hook and loop straps. If the battery moves fore or aft,
use hook and loop (not provided) mounted directly to the
battery and the tank floor to keep the battery secure inside
the fuselage.
 Step 4
Attach the X-mount to the motor using the screws
provided with the motor.
Note: Make sure to use threadlock on the
screws to prevent them from vibrating loose.
 Step 5
Attach the motor to the firewall using four 1 5 /
8
-inch
(50mm) aluminum standoffs and four 8-32 x 2 1 /
2
-inch
(64mm) machine screws.
Note: Make sure to use threadlock on the
screws to prevent them from vibrating loose.
Section 9: Electric Motor Installation