Hangar 9 Piper Pawnee 40 ARF - Manual (Page 34)

34
 Step 8
Slide a clevis retainer onto a clevis, then thread the clevis
onto the 17 3 /
4
-inch (450mm) throttle pushrod.
 Step 9
Slide the pushrod into the tube and connect the clevis to
the carburetor arm.
 Step 10
Attach the muffler to your engine following the instructions
provided with your particular engine.
 Step 11
Look carefully at the fuel tank to determine which tubes
are for the carburetor and vent. Also check the direction
of the vent line inside the fuel tank. The vent will face the
top of the fuselage when the fuel tank is installed. Use the
drawings below as a reference for the fuel lines.
Clunk
Vent line
Top View
Side View
Vent line (faces top of fuselage)
To Muffler
To Carburetor
Section 6: 2-Stroke Engine Installation