Kistler-Morse KM STXPlus User Manual
Page 17
CHAPTER 3: STAND-ALONE ANALOG CALIBRATION AND SET UP
Figure 3-4. DSP Filter Examples.
TARE
The tare feature allows you to tare or “zero”
a vessel. Tare is useful when you want to
monitor how much material is added to or
removed from the vessel from a given point.
The effect is as follows:
1. If the STXplus current output is in net
mode, the current output will correspond
to the change in weight since the last
time the vessel was tared, rather than
the total weight of material in the vessel.
2. With serial communications a tare can
be performed. If setpoints are set up
based on net weight, their activation will
correspond to the net weight.
3. If the STXplus is stand-alone, press the
ENTER button when no PARAM LEDs
are lit.
4. A calibration should only be done while
in gross mode.
3-8