Kofax Capture Export Connector - Manual (Page 11)

Ascent® 7.5 Release Script for Documentum 6.0-6.5 Release Notes
Kofax, Inc. 7
Important Notes About Installing the Export Connector
You must have Windows administrator privileges. If you do not have administrator privileges
and install this export connector, you may receive error messages and several of the files may not
install correctly.
Separate Computers
You must install the Kofax Capture software and the Documentum server components on separate
computers. If you install Documentum and Kofax Capture on the same computer, communication
between any Documentum components and the DocBroker will fail. This is an unsupported
configuration. (SPR 00009740)
Installation Instructions
Use the following instructions to install the Ascent® 7.5 Release Script for Documentum 6.0-6.5.
X To install the export connector
1 Insert your installation CD into your CD drive.
2 From your Windows task bar, select Start | Run, browse to the
Documentum\Documentum6 folder on the CD, and run Setup.exe. The installation
program will start.
3
Follow the instructions on your screen to install the export connector.
4 When the installation is complete, a message will display that indicates the export
connector was successfully installed.
Note Installing the export connector automatically registers it with Kofax Capture.
5 Repeat this procedure on all Administration and Export workstations that will use the
export connector.
Note Upgrading from a previous export connector is not supported.
Application Maintenance
This section describes how to repair and remove the export connector.
Repairing the Export Connector
The Repair option replaces missing, renamed, or deleted files.
X To repair the export connector
1 Insert the installation CD into your CD drive.
2 From your Windows task bar, select Start | Run, browse to the
Documentum\Documentum6 folder on the CD, and run Setup.exe.
3 Setup will detect an existing installation and the Application Maintenance window will
display.