Kofax Communication Server 10.0.0 - Manual (Page 10)

About This Release
10 Kofax Communication Server Release Notes
The registry key is created at TC/LINK startup. The default break code value of all the errors
is set to '0' ( "LV=0 LX=0 LH=0 LI=0 M1=0")
The break code value can be set from 1 to 5. Based on this value, the message retries are
initiated.
Changes in Behavior
This section contains information about the differences in behavior between Kofax
Communication Server 10.0.0 and previous releases.
Tandem Improvements
With the improved behavior, Tandem Server now should never go into the desynchronized
state at the expense of not running at all in certain error situations. This is the default and
the recommended setting. As a consequence of the new default, the primary master stops
automatically if neither the secondary master nor the status agent can be reached. (318258)
The improvements can be deactivated using a new registry value
HKEY_LOCAL_MACHINE/
SOFTWARE/Topcall/TCOSS/RunWithoutStatusAgent
, which must be set identically on both
primary and secondary master:
▪ 0 - Never run without proper quorum (default value)
▪ 1 - Primary/Secondary master can run stand-alone without status agent
See Tandem Server Technical Manual for more details.
TC/LINK-FI Does Not Start - FilesBlackList Full
Read-only files can fill up the registry value
FilesBlackList
. As a result, TC/LINK-FI does
not start. (321020)
TC/LINK-FI now creates a registry value
HKEY_LOCAL_MACHINE\SOFTWARE\Wow6432Node
\TOPCALL\TCLINKFI\Options\In\ReadOnlyFlagRemove
during its startup. Use this registry
value to configure whether read-only files are deleted.
▪ 1 - Delete read-only files (default value)
▪ 0 - Do not delete read-only files.
See TC/LINK-FI Technical Manual for more details.
Document Converter: Zero-Length Files
For the registry key
KeepEmptyAttachments
, the default value is now 0 - empty attachments
are silently ignored.
TCOSS: Outgoing Voice Calls Enabled
For Kofax Communication Server 10 installations, UIF/UFI configuration line 295, position 1
“Outgoing voice calls” is now enabled (01) by default. When upgrading to KCS 10, the value
is not modified. (318311)
See TCOSS Configuration Manual for more details.