Cisco 2960 - Manual (Page 5)

5
Step 7 Connect a Category 5 Ethernet cable
to any 10/100 or 10/100/1000
Ethernet port on the switch front
panel.
Connect the other end of the cable to
the Ethernet port on your PC.
Step 8 Verify that the LEDs on both Ethernet ports are green. Wait 30 seconds.
Step 9 Start a web browser on your PC.
Enter the IP address 10.0.0.1 in the
web browser, and press Enter.
The Express Setup page appears. If it does not appear, see the “In Case of Difficulty” section
on page 16 for help. You entries should be in English.
DHCP-enabled PC
210109
2x 3x 4x 5x 6x 7x 8x
1
Catalyst 2960
Series
CONSOLE 1x SPD
DPLX STAT
SYST
MODE