5 installing the switch, Equipment that you supply, Installing the switch – Cisco 2960 User Manual
Page 9
9
The Cisco Configuration Engine is a network management device that works with embedded CNS
agents in the switch software. You can use Cisco Configuration Engine to automate initial
configurations and configuration updates on the switch.
See the “Accessing Help Online” section on page 18 for a list of supporting documentation.
5
Installing the Switch
This section describes installation information specific to the Catalyst 2960-8TC, Catalyst
2960G-8TC, and Catalyst 2960PD-8TT-L switches. For information applicable to the other
Catalyst 2960 switches, see the Catalyst 2960 Switch Hardware Installation Guide on Cisco.com,
which includes installation instructions for all Catalyst 2960 switch models.
This section covers desk-, shelf-, and magnet-mounting. As an example, all the illustrations show the
Catalyst 2960-8TC switch. For alternate mounting procedures, such as installing the switch in a rack
or on a wall, see the Catalyst 2960 Switch Hardware Installation Guide on Cisco.com.
Equipment That You Supply
You need this equipment to install the switch:
•
Number-2 Phillips screwdriver
•
Drill with a #27 drill bit (0.144-inch [3.7 mm])