Acura 2007 RL - Owner's Manual - Manual (Page 211)

Use the TUNE button to
tune the radio to a desired frequency.
Press the
button to tune to a
higher frequency, or the button
to tune to a lower frequency. To tune
with the interface dial, push the
selector down, and turn the knob to
TUNE. Then press ENTER on the
selector, and turn the knob to the
desired frequency. To exit the
TUNE mode, press ENTER on the
selector. You can use any of five methods to
find radio stations on the selected
band:
the
preset buttons, and .
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Press the AUDIO button to
view the audio control display. Turn
the system on by pressing the
power/volume knob or the AM/FM
button (AM or FM button on
Canadian and Hawaiian models).
Adjust the volume by turning the
power/volume knob.
The band and frequency that the
radio was last tuned to are shown on
the display. To change bands, press
the AM/FM button (AM or FM
button on Canadian and Hawaiian
models). You can also change bands
by pushing the interface selector up.
Each time you push it up, the band
will change to FM1, FM2, or AM. On
the FM bands, STEREO will be
shown on the navigation screen and
ST on the upper display, if the
station is broadcasting in stereo.
Stereo reproduction on AM is not
available.
CONTINUED
TUNE
To Select a Station
TUNE, SEEK, SCAN,
AUTO SELECT
Audio System
Fe
a
tu
re
s
209
STEREO ICON
TUNE ICON
BAND
Main Menu Table of Contents