Acura 2007 RL - Owner's Manual - Manual (Page 212)

The SEEK function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press the
or SEEK button,
then release it. You can also activate
SEEK by pushing the interface
selector to the right or left.
The SCAN function
samples all stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it.
Each preset button or
preset icon can store one frequency
on AM and two frequencies on FM.
Use the tune, seek, or scan
function to tune the radio to a
desired station.
To scan with the interface dial, push
the selector down, and then push it
to the right. You will see SCAN
flashing on the screen and the upper
display.
The system will scan for a station
with a strong signal. When it finds
one, it will stop and play that station
for about 10 seconds. If you do
nothing, the system will then scan
for the next strong station and play it
for 10 seconds. When it plays a
station that you want to listen to,
press the scan button again, or push
the interface selector to the right
again.
Select the desired band, AM or
FM. FM1 and FM2 let you store
two sets of FM frequencies with
the preset buttons (on-screen
icons).
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
Press the preset button, and hold
it until you hear a beep. You can
also store frequencies with the
interface dial. Select the preset
icon you want to store the
frequency on, then press ENTER
on the interface selector, and hold
it for more than 2 seconds.
4.
1.
2.
3.
To store a preset memory location:
SEEK
SCAN
Preset
Audio System
210
SCAN ICON
Main Menu Table of Contents