American Access Systems ProAccess 200sa - Manual (Page 8)

SK-ACP Installation & Operating Manual
4
INSTALLATION
CAUTION SHOULD BE TAKEN NOT TO TOUCH CIRCUIT BOARD OR ELECTRONIC COMPONENTS PRIOR
TO AND DURING INSTALLATION TO AVOID ELECTRO-STATIC DISCHARGE (ESD) DAMAGE.
INSTALLING THE SK-ACP
1. Select a location for the SK-ACP unit that is secure and sheltered from weather and extreme humidity. Choose
a location that facilitates access to power and is reasonably close to the doors that are to be controlled (no
further than 500 feet).
2. Using the unit as a template, mark on the mounting surface the location of the four mounting holes.
3. Install appropriate mounting hardware (anchors, retainers, etc.) to the mounting surface if necessary.
4. Screw #6 or #8 mounting screws into the top 2 mounting holes of the mounting surface, leaving about 1/4”
clearance.
5. Place panel top key-way mounting holes over installed mounting screws and slide panel down.
6. Tighten top mounting screws.
7. Install two bottom mounting screws (see figure 2).
8. Route cables into the enclosure through
knockouts in sides or back of box, being
careful not to nick or scrape insulation
on any rough edges.
FIGURE 2