Crestron electronic DigitalMedia Repeater DM-DR - Manual (Page 10)

DigitalMedia
™
Repeater Crestron DM-DR
Connectors, Controls & Indicators (Continued)
# CONNECTORS
1
,
CONTROLS &
INDICATORS
DESCRIPTION
6 SOURCE
2, 3
(1) DM port composed of (2)
8-pin RJ-45 female
Connects to DM output of a
DM switcher, transmitter, or
other DM device via DM-CBL
or CresCAT-D cable
4
7 SOURCE 24 A B G
5, 6
(1) 4-pin 3.5mm detachable
terminal block, DMNet port.
Connects to DMNet port of a
DM switcher, transmitter, or
other DM device via DM-CBL
or CresCAT-D cable
4
1. Interface connectors for SOURCE/DISPLAY 24 A B G ports are provided with
the unit.
2. The source and display ports consist of two separate RJ-45 ports that are labeled
D and M. The D port carries video signal. The M port carries data. Refer to the
tables below, and on the following page, for the wires pin assignments.
D Port
PIN # SIGNAL DESCRIPTION
1 DATA D0+ HDMI Blue
2 DATA D0- HDMI Blue
4 DATA D1+ HDMI Green
5 DATA D1- HDMI Green
7 DATA D2+ HDMI Red
8 DATA D2- HDMI Red
3 CLK- HDMI Clock
6 CLK + HDMI Clock
6
• DigitalMedia ™ Repeater: DM-DR Operations & Installation Guide – DOC. 6745A