Crestron electronic DigitalMedia Repeater DM-DR - Manual (Page 14)

DigitalMedia
™
Repeater Crestron DM-DR
• Metal mounting plate (supplied)
• 4-Pin connector plugs (supplied)
It is assumed that DigitalMedia cable (DM-CBL) has been fed through an
installed two-gang electrical box, 85mm European or 1900 box electrical
box (not supplied) and wiring has been verified. Use the following
procedure to install the DM-DR.
NOTE: Cables in the electrical box should be tagged as source and
display.
1. Confirm that DMNet system power is OFF.
2. Attach supplied connector plugs according to the pinout on pages 6
and 7.
3. Attach metal mounting plate to electrical box using two Phillips
screws (not supplied).
4. Make SOURCE connections using DM-CBL.
• Connect the DMNet cable with the supplied connector plug to
the DM-DR’s SOURCE 24 A B G port.
• Connect the RJ-45 terminated blue shielded DigitalMedia cable
to the SOURCE D port.
• Connect the RJ-45 terminated yellow CAT5e/CAT6 cable to
the SOURCE M port.
5. Make DISPLAY connections using DM-CBL.
• Connect the DMNet cable with the supplied connector plug to
the DM-DR’s DISPLAY 24 A B G port.
• Connect the RJ-45 terminated blue shielded DigitalMedia cable
to the DISPLAY D port.
• Connect the RJ-45 terminated yellow CAT5e/CAT6 cable to
the DISPLAY M port.
6. Attach DM-DR to mounting plate using four #06-32 x 1/4" Phillips
screws (supplied) as shown in illustration on the following page.
10
• DigitalMedia ™ Repeater: DM-DR Operations & Installation Guide – DOC. 6745A