AvMap GeoPilot Plus - Manual (Page 18)

18
‘MENU’: press & hold for 1 seconds: opens the Main Menu (equivalent to press ‘MENU’ twice).
the Cycle key
Allows the user to quickly change the data viewed on the Moving Map between three pre-set
mapping/navigation screens.
2.2 tUrNING thE GEoPILot oN/oFF
Before powering On the GEOPILOT, check for the correct voltage (10-35 Volt DC).
2.2.1 turning on
Press and hold ‘POWER’ for 1 second. The GEOPILOT emits one rapid beep sound and a Title page
containing information about the Product name, Software version, library version and cartridges
installed is displayed. This data can also be viewed in the “About” page in the “Main Menu”.
Fig. 2.2.1 - Title page
After a few seconds the Warning page is displayed, reminding you that the GEOPILOT is an aid to
navigation and should be used with appropriate prudence. The electronic charts are not intended
to substitute for the official charts. Press ‘ENT’ to open the Moving Map screen.
2.2.2 turning off
‘POWER’ 3 sec.: a countdown timer appears on the screen, if you release the key before the
countdown timer reaches zero, the GEOPILOT will remain On.
2.3 ChANGING BrIGhtNESS & CoNtrASt
Press and immediately release ‘POWER’ to adjust the brightness and the contrast of the display and
keyboard (do not press and hold the key or the “power-off ” message will be displayed!).
To increase/decrease the brightness use respectively up/down cursor key. Similarly, to increase/
decrease the contrast use left/right cursor key. In addition the Time and the GPS State are shown.
2.4 SELECtING thE LANGUAGE
It is possible to select the language in which the information is displayed (for screen labels, menus
and options, but it does not affect the map information). The default setting is English.
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENT’ + “GENERAL SETUP” + ‘ENT’ +
“LANGUAGE” + ‘ENT’