Figure 2-1, Table 2-1 – Cisco 545 Serial User Manual

Page 22

Advertising
background image

2-2

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.5

OL-14912-01

Chapter 2 Installing the Cisco Unified Videoconferencing 3545 Gateway

Physical Description

Figure 2-1

Gateway Front Panel

Cisco Unified Videoconferencing 3545 PRI Gateway RTM

The Rear Transition Module (RTM) provides the PRI line connections for the Cisco Unified
Videoconferencing 3545 PRI Gateway.

Figure 2-2

shows the RTM panel components of the Cisco Unified Videoconferencing 3545

PRI Gateway module.

Table 2-2

describes these components.

Figure 2-2

PRI Gateway: Rear Transition Module

Table 2-1

Front Panel Components

Component

Description

10/100 Base T-1
connector

An RJ-45 connector that provides the primary Ethernet connection for the IP
network port.

SERIAL connector

A DB-9 connector that allows you to connect a PC terminal for local
configuration.

RST button

Allows you to reset the gateway manually.

GK Reg LED

Lights green when the gateway is registered with a gatekeeper.

CD LED

Lights green when at least one gateway port connection is online.

ACT LED

Lights green to indicate that there are active calls in the gateway.

ALARM LED

Lights green to indicate that an error has occurred and the gateway requires
resetting.

10/100 Base T-1 LEDs

The top part of the 10/100 Base T-1 connector contains two LED indicators.
The left-hand LED lights green when the local IP network link is active. The
right-hand LED lights green if the connection speed is 100 Mbps, and is off
when the connection speed is 10 Mbps.

SWAP RDY LED

Hot Swap indication. Lights blue when the latches of a board are unlocked
and it is safe to remove the board from the chassis. Goes off when the board
is completely detached.

157269

10/100Base T-1

SERIAL

RST

ACT

ALARM

CD

GK Reg

SWAP

RDY

Table 2-2

PRI Gateway Rear Transition Module Components

Component

Description

ACT LEDs

Lights green to indicate that there are active calls in the gateway.

D-Ch LEDs

Lights green to indicate that the PRI line is enabled and a carrier signal is
detected.

157272

PORT-1

PORT-2

ACT

D-Ch

ALARM

ACT

D-Ch

ALARM

Advertising