Blinds Chalet Good Housekeeping 2 Wood Blinds - Manual (Page 3)

3
STEP 1: MOUNTING THE BRACKETS
The installation brackets may be used for INSIDE, OUTSIDE or CEILING mounts.
The brackets are stamped R.H. (right hand) and L.H. (left hand) for easy
identification.
Mounting the brackets level is essential for proper operation of the blind. Shim
the brackets if necessary to achieve a level alignment.
SPACER BLOCKS (3/8” standard for 2-3/8” & 2-1/2” slats):
ƒ
Spacer blocks will be attached to the end of each bracket.
ƒ If installing extension brackets, do not use spacer blocks.
spacer block to end of bracket, shim to top of bracket (if necessary)
INSIDE MOUNTS:
For inside mounts the installation brackets may be screwed in place either through
the side or through the top holes of each bracket.
ATTACH THE BRACKETS:
ƒ
For better side mounting, screw through one side and one top hole.
ƒ For limited surface depths, screw through two diagonal side holes.
ƒ For top mounting, screw through the two top holes.
Inside mount bracket screwed
through side and top holes.
CENTER SUPPORT BRACKETS (if required):
ƒ
Space evenly between the two end brackets.
ƒ Adjust if necessary to avoid interference with internal headrail parts.
ƒ Attach with screws through two diagonal holes.
Blind Width Center Support Brackets
12” to 48” 0
48-1/8” to 60” 1
60-1/8” to 120” 2