Blinds Chalet Good Housekeeping 2 Wood Blinds - Manual (Page 9)

9
ADJUST PROJECTION
PIVOT
& SECURE
4. SECURE: Secure the valance safety straps.
These should be out in front of the headrail per the
instructions in STEP 3: INSTALLING THE BLIND.
ƒ
Pivot the valance by gently lifting the bottom of
the valance up and out. There are 2 safety
straps included with your blind located at each
end of the headrail (just 1 strap for valances
under 36” wide located in the center).
ƒ
Attach the safety straps to the valance by
grasping each clip at the end of each strap,
then twisting the clips into the valance route
until straight (same as magnetic clips).
ƒ
THE SAFETY STRAPS MUST ALWAYS BE ATTACHED.
5. ADJUST: the valance projection as follows;
FOR INSIDE MOUNT VALANCES – after securing the
valance safety straps, continue pressing the valance
forward until it is flush with the wall or until the
magnetic clips are in their fully compressed position.
FOR OUTSIDE MOUNT VALANCES – after securing
the valance safety straps, continue pressing the
valance forward until there is a 1/8” clearance gap
between the valance returns and the wall or until the
valance returns are touching the wall (for a tighter fit).
VALANCE HEIGHT ADJUSTMENTS - The magnetic valance clips allow for limited
valance height adjustments by carefully sliding the valance up or down while the
magnets are adhered to the headrail. The magnetic clip’s stop lip tabs rest on the
top front lip of the headrail, keeping the valance level and preventing the valance
from adjusting lower beyond that point.
CAUTION: THE ENTIRE SURFACE AREA OF THE MAGNET INSIDE EACH CLIP NEEDS TO
MAINTAIN CLEAN CONTACT WITH THE FRONT SURFACE AREA OF THE HEADRAIL AT ALL TIMES.
5/8” 7/8”
The clip projection diagrams
measure the distance between the
back of the valance and the front of
the headrail.
For outside mounts with 3” valance
returns, the standard clip projection
is 1 notch out from the clip’s narrow
(fully compressed) position.