BMW 2013 3 Series User Manual
Page 200
Daytime running lights
24-watt bulb, PW24W
1.
If necessary, remove the high beam bulb
connector.
2.
Remove the bulb holder.
3.
Remove the bulb from the bulb holder.
4.
To insert the new bulb, proceed in reverse
order of removal. During insertion, the bot‐
tom of the bulb holder must be facing down‐
ward. Make sure that the bulb holder snaps
into place.
5.
Attach the high beam bulb connector.
6.
Close the headlamp housing with the cap.
Make sure that the cap engages.
Xenon headlamps
Xenon headlamps
Because of the long life of these bulbs, the like‐
lihood of failure is very low. Switching the lamps
on and off frequently shortens their life.
If a xenon bulb fails, switch on the front fog lamps
and continue the trip with great care. Comply
with local regulations.
Do not perform work/bulb replacement on
xenon headlamps
Have any work on the xenon lighting system, in‐
cluding bulb replacement, performed only by a
service center. Due to the high voltage present
in the system, there is the danger of fatal injuries
if work is carried out improperly.◀
For checking and adjusting headlamp aim,
please contact your BMW center.
Headlamps
1 Parking lamps / daytime running lights
2 Low beams/high beams/headlamp flasher
3 Turn signal
Low beams and high beams are designed with
xenon technology.
The parking lamps and daylight running lights
are made using LED technology.
Contact your service center in the event of a
malfunction.
Turn signal
Follow the general instructions on lamps and
bulbs, refer to page
Seite 200
Mobility
Replacing components
200
Online Edition for Part no. 01 40 2 903 880 - 07 12 490