Boekel Scientific 230402-2 Big S.H.O.T. III - Manual (Page 8)

8
key pro vided and slide collar to the right side of the shaft. The two “flats” can
now be separated. Remove Carousel by sliding it to the right and then out. To
install Carousel, reverse procedure. Warning! Sharp rotating parts. Do not
attempt to remove the carousel until motor has stopped. Remove power from the
equipment. Use caution when removing the carousel since it may be very hot.
4.9 Drip Tray
To access the drip tray for cleaning, the tray is designed to slide out without
removing the carousel. Use caution when removing the drip tray since it may be
very hot.
4.10 Reducing the risk of a Hybridization Bottle leak
4.10.1 Glass Hybridization Bottles
Avoid over-tightening the cap, which can twist or cause a gap in the O Ring seal.
Turn the cap a few degrees of arc past the point where the cap is seated to the
bottle.
Replace the O Rings before they become worn, flat or cracked. We suggest
replacement after 10 hybridization runs.
4.10.2 50ml Conical Centrifuge Tubes
Be sure to use tubes that can handle the elevated temperatures used in
hybridization. We recommend that you contact your supplier or tube
manufacturer. In general, scientists have found that tubes made from
polypropylene with polyethylene caps provide reliable performance. Tubes made
from polystyrene should be avoided.
When inserting the centrifuge tube into the clamping mechanism, place the
clamp toward the middle of the tube. Pinching the tube near the cap may cause
a leak.
5. Accessories
Model Number Description
Glass Hybridization Bottles, 2/package
502-0100
35mm X 100mm
502-0150 35mm X 150mm
502-0225 35mm X 225mm
502-0300 35mm X 300mm
Caps and “O” Rings for Glass Hybridization Bottles
505-0001
Blue caps with silicone “O” rings, package of 2
502-0500 Replacement silicone
“O” rings for blue caps, package of 10
509-0009 Red caps, package of 2
Large Acrylic Bottles and Gaskets
502-0009
70mm X 220mm (750mL)
502-0010 55mm X 180mm (400mL)
A1902701 Gasket for 502-0009 Bottle