Boekel Scientific 230502-2 Little S.H.O.T. III - Manual (Page 10)

10
7. Technical Specifications
This equipment is for indoor use and will meet its performance figures within the
ambient temperature range of 0

C to 35

C, with maximum relative humidity of 80% non-
condensing.
Temperature range (Ambient +10

C) to 80

C.
Stability +/- 0.5

C
Overall accuracy +/- 0.5

C
Temperature display resolution 0.1

C
Supply ratings 230502 115V±10%, 2.8A, 60Hz.
230502-2 230V±10%, 1.6A, 50/60Hz.
Power ratings 230502 340W
230502-2 340W
Heating rate Ambient to 65

C within 20 minutes
Speed rotation 5 – 60 RPM
A minimum of at least two bottles is needed for optimum temperature stability..
8. Maintenance and Service
No routine maintenance is required.
8.1 Calibration
This product has been factory calibrated for optimum performance. A pedigreed
individually serialized thermistor is used to monitor and control temperature in
this unit. These thermistors are +/- 0.1° C absolute accurate, and +/- 0.01°C
reproducible over time (for a given unit). The thermistor R-T table is stored
digitally and is reproducible from unit to unit without the need of an individual
calibration or re-calibration over item. Additionally, thermal modeling of the
instrument allows for the inclusion of digital offsets to the R-T table in FLASH
memory which eliminates the need for individual unit calibration. However, if a
user has a specific need to recalibrate or add a temperature offset, please
c
ontact the “Boekel” customer service department at 1-800-336-6929, to request
a copy of the calibration procedure.
8.2 Cleaning
Disengage power cord prior to cleaning. The floor of the chamber is protected
with a removable stainless steel drip tray. If a spill occurs, use appropriate clean
up procedures as required for radiation or biohazard control. The outer casing
can be cleaned with a cloth dampened with water. Do not submerge or immerse
the Little SHOT in water. The Acrylic lid must not be cleaned with any abrasive
type cleaning agent. This will cause severe scratching of this material. Before
using any cleaning or decontamination method except those recommended by
the manufacturer, users should check with the manufacturer that the proposed
method will not damage the equipment.