Boekel Scientific 230502-2 Little S.H.O.T. III - Manual (Page 6)

6
4.2 Changing the Set Temperature

Press the “F” button once until TSEt is indicated on the display. The display
will alternate between TSEt and the set temperature value.

Press the
“S” button to enter the “Set Temperature” mode.

Adjust the Increment / Decrement Dial until the desired new Set
Temperature is indicated on the display.

Press the
“S” button to accept and store the new value in memory.
4.3 Setting the Motor Speed
To enter a new motor speed”

Press the “F” button until SPd is indicated on the display. The display will
alternate between SPd and the current motor speed value.

Press the
“S” button to enter the “Motor Speed” mode.

Use the Increment / Decrement Dial to obtain the required motor speed.
The display flashes when in the “Set Motor Speed” mode.

When the desired motor speed is indicated, press
“S” again. This value is
then stored in memory and the unit will retain this value after unit is switched
off.
4.4 Using the Timer
The timer can be programmed up to 99 hours and 59 minutes. At the end of the
timed operation the heater will shut off but the carousel will continue to operate
for an additional 2 hours.
The default condition of the timer is “off”.
To turn the timer on and set the timer duration:

Press the “F” button three times until CLOC is indicated on the display.
Press the
“S” button to enter the “Clock” mode.

Dial the Increment / Decrement Dial clockwise to turn
“On” the timer.

Press the “S” button to enter the “Clock Adjust” mode.

Use the Increment / Decrement Dial to obtain the required timer value. The
display flashes the present clock setting (HH.MM) when in the
“Clock
Adjust ” mode.

When the desired timer duration is indicated, press “S” again. This turns the
timer on and stores the timer duration in memory. The display will alternate
between the chamber temperature and the time remaining.
To turn the timer off when unit is operating in timed operation:

Press the
“F” button three times until CLOC is indicated on the display.

Press the
“S” button to enter the “CLOCK” mode.

Dial the Increment / Decrement Dial counter clockwise to turn “Off” the
timer. Press the
“S” button to accept the timer off condition, the unit will
return to normal operating mode.