Boekel Scientific 230502-2 Little S.H.O.T. III - Manual (Page 11)

11
8.3 Replacement of Fuses

Disconnect the unit from the power supply.

Remove the plug from the socket in the back of the unit.

Pull back on the fuse drawer catch.

Pull out the fuse drawer (see Figure 4).

Check and replace with the correct fuses if necessary.

The fuses should be 5mm x 20mm:
230502 (115V) 4.0A/250v 3AG SLO-BLO
230502-2 (230V) 4.0A/250v 3AG SLO-BLO

Push the fuse drawer back in. Reconnect unit to the power supply.
Figure 4
9. Warranty
When used in laboratory conditions and according to these operating instructions
Boekel warrants this product to be free of defective material and workmanship for a
period of two years from the date of manufacture. The liability of Boekel for any
defective equipment during the warranty period shall be limited to the repair of
such equipment or replacement thereof without charge for parts or labor.
OPEN FUSE
HOLDER AT
THIS POINT
BY PULLING
DOWN.
FUSE DRAWER
PULL OUT TO
REMOVE.
POWER
SWITCH
BE SURE THAT THE
PROPER VOLTAGE
APPEARS AT THE
ENTRY WINDOW
WHEN REINSTALLING.