Whirlpool 3ET16NK - Manual (Page 12)

Removing the crispers and crisper cover
For your convenience, one crisper is slightly
larger than the other. This allows you to
store celery and other longer items in your
crisper.
To remove the crispers:
1. Slide crisper straight out to the stop.
2. Lift the front.
3. Slide out the rest of the way.
4. Replace in reverse order.
To remove the cover:
1. Push up the cover insert from the bottom,
then slide out with both hands.
2. Lift front of cover frame.
3. Lift cover frame up and out.
To replace the cover:
1. Fit back of cover frame into notch sup­
ports on back wall of refrigerator, then
lower the front into place.
2. Slide back of cover insert into place, then
lower the front.
Remove the
cover insert.
Lift the cover
front, then the
back.
NOTE: If
cover insert
is glass,
handle it with
care. It could
be heavy.
Pull out to
the stop,
lift the
front and
pull again.
Adjusting the crisper cover track
Because your crispers are not the same
size, your crisper cover has an adjustable
center track so you can switch positions of
the crispers. You can adjust the center track
with the cover in the refrigerator by removing
the crispers and the cover insert.
To remove the center track:
1. Push up the cover insert from the bottom,
then slide out with both hands.
2. Gently pull up on front end of track.
3. Pull rear end of track out of opening in
cover.
To replace the center track:
1. Insert rear end of track (with hole) Into
opening in cover.
2. Lower front end of track into slot.
3. Make sure rear end of track has snapped
into place on under side of cover.
11