Removing freezer bin, To remove the bln, Ice cube trays – Whirlpool ED19EK User Manual
Page 7: Changing the light bulbs, Removing the base grille, To replace
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Removing freezer bin...
For proper air movement, keep the freezer bin in
place when the refrigerator is operating.
To remove the bln:
• Slide out to the stop.
• Lift the front to clear the stop.
• Slide out the rest of the way.
To replace the bln:
• Place bin on the slides.
• Make sure the stops clear
the front of the slides.
• Slide bin in.
Ice cube trays...
If cubes are not used, they may shrink. The moving
cold air starts a slow evaporation. The longer cubes
are stored, the smaller they get.
To remove ice:
1. Hold tray at both ends.
I 2. Slightly twist.
Changing the light bulbs...
WARNING: Before removing the light shield for
cleaning or for replacing the bulb,
unplug the refrigerator or turn off
electricity leading to refrigerator at
the main power supply. Shock and
injury could occur.
Light buibs behind refrigerator and freezer con
trol consoles:
1, Pull control knob straight off.
2, Pull bottom of control panel straight out.
3, Lift top of panel off supports.
4, Replace with a 40-watt appliance bulb.
5, Replace panel in reverse order
Removing the base grille...
1 Open the doors.
2, Pull grille outwards as shown.
3. Do not remove Tech sheet fastened behind grille.
-Metal Clips'
Metal Clips
Support Tabs I
To replace:
1, Line up grille support tabs with metal clips.
2, Push firmly to snap into place.
3, Close the doors.