To change dispenser area light (on some models), Understanding the sounds you may hear, Slight hum, soft hiss – Whirlpool 4YED27DQDN00 User Manual

Page 21: Clicking or snapping sounds, Water sounds, Ice maker sounds, Running sounds, Saving energy

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

To change dispenser area light (on
some models):

1. Disconnect refrigerator from power supply.

2. Reach through dispenser area to

remove bulb.

3. Replace with a heavy-duty 10-watt bulb,

which can be purchased from your
Whirlpool dealer.

4. Reconnect refrigerator to power supply.

NOTE; Not all appliance bulbs will fit your

refrigerator. Be sure to replace a bulb with
one of the same size and shape.

Dispenser area light

Understanding the sounds you may hear

Your new refrigerator may make sounds that
your old one didn’t. Because the sounds are
new to you, you might be concerned about
them. Don’t be. Most of the new sounds are

normal. Hard surfaces like the floor, walls, and
cabinets can make the sounds seem louder.

The following describes the kinds of sounds

that might be new to you, and what may be

making them.

Slight hum, soft hiss

You may hear the refrigerator’s fan motor and

moving air.

Clicking or snapping sounds

The thermostat makes a definite click when
the refrigerator stops running. It also makes a
sound when the refrigerator starts. The defrost
timer will click when the defrost cycle starts.

Water sounds

When the refrigerator stops running, you

may hear gurgling in the tubing for a few
minutes after it stops. You may also hear
defrost water running into the defrost water
pan.

Ice maker sounds

• trickling water
• thud (clatter of ice)

You may hear buzzing (from the water
valve), trickling water, and the clatter of ice
dumped into the bin.

Running sounds

Your refrigerator has a high-efficiency
compressor and motor. It will run longer
than older designs. It may even seem to
run most of the time.

Saving energy

You can help your refrigerator use less
electricity.
• Check door gaskets for a tight seal. Level

the cabinet to be sure of a good seal.

• Clean the condenser coils regularly.
• Open the door as few times as possible.

Think about what you need before you

open the door. Get everything out at one

time. Keep food organized so you won’t

have to search for what you want. Close
door as soon as food is removed.

20

' Go ahead and fill up the refrigerator, but

don’t overcrowd it so air movement is
blocked.

’ It is a waste of electricity to set the refrig­

erator and freezer to temperatures colder
than they need to be. If ice cream is firm
in the freezer and drinks are as cold as
your family likes them, that’s cold enough.

' Make sure your refrigerator is not next to

a heat source such as a range, water
heater, furnace, radiator, or in direct
sunlight.

Advertising