Before using your refrigerator, Cleaning your refrigerator, Removing packaging materials – Whirlpool 4YED27DQDN00 User Manual
Page 7: Cleaning it before use, Plugging it in
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before Using Your
Refrigerator
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it, and level it.
Cleaning your refrigerator
Removing packaging materials
Remove tape and any inside labels (except
the model and serial number label) before
using the refrigerator.
To remove any remaining giue:
• Rub briskly with thumb to make a ball,
then remove.
OR
• Soak area with liquid hand-dishwashing
detergent before removing glue as
described above. Do not use sharp
instruments, rubbing alcohol, flammable
fluids or abrasive cleaners. These can
damage the material. See “Important
Safety Instructions” on page 3.
NOTE: Do not remove any permanent
instruction labels inside your refrigerator. Do
not remove the Tech Sheet fastened under
the refrigerator at the front.
Cleaning it before use
After removing all packaging
materials, clean your refrigera
tor before using it, if necessary.
See cleaning instructions on
pages 21-22.
Plugging it in
Recommended Grounding Method
A 115 Volt/60 Hz (Plug 1), 220/240 Volt/50
Hz (Plug 2 or 3) or 220 Volt/60 Hz (Plug 3)
AC only 15 or 20 ampere fused and properly
grounded electrical supply is required. It is
recommended that a separate circuit serving
only this appliance be provided. Use a
receptacle which cannot be turned off with a
switch or pull chain. Do not use an extension
cord.
Plugl
Plug 2