Cisco DPQ3212 - Manual (Page 38)

38 4019777 Rev B
How Do I Maintain the Battery?
Location of Battery
As shown in the following illustrations, the battery compartment is located on the
right side panel for both DPQ3212 housing types.
Housing Type 1
Housing Type 2
Before Removing and Replacing the Battery
Before removing and replacing the battery, refer to the following important
information.
 You can remove and replace the battery without disconnecting the AC power
source.
 It may take as long as 24 hours for each battery to charge fully.
 Dispose of the battery in accordance with local regulations and instructions from
your service provider.
Removing and Replacing the Battery, Housing Type 1
1 Open the battery door by operating the battery door lock on the side of the unit.
2 Grasp the plastic pull-tab on the battery and gently slide the battery forward to
remove it from the battery compartment.
3 Insert a new battery into the battery compartment.
4 Close the battery compartment door.
Removing and Replacing the Battery, Housing Type 2
1 Open the battery door by pressing on the battery door where indicated on the
side of the unit.
2 Slide the gray battery lock release inside the battery compartment upward to
disengage the battery lock.
3 Grasp the plastic pull-tab on the battery and gently slide the battery forward to
remove it from the battery compartment.
4 Insert a new battery into the battery compartment.
5 Close the battery compartment door. The battery lock will automatically engage.