Cisco 7200 VXR User Manual
Page 13
13
Figure 7
Attaching the Rack-Mount Brackets to the Rear of the Chassis—Front Protrudes from the Rack
Brackets Rear-Mounted—Front Protrudes from the Rack
Step 1
Locate the threaded screw holes in the rear sides of the chassis.
Step 2
Align a rack-mount bracket (1) to the threaded holes in the right side of the chassis.
Step 3
Using a Number 2 Phillips screwdriver and two M4 x 8-mm Phillips flathead screws (2), attach the rack-mount bracket
to the router.
Step 4
Repeat Steps 2 and 3 for the bracket on the other side of the router. If you are not installing cable-management brackets,
skip to the “Two-Post or Four-Post Rack Installation” section on page 16 for rack-mount instructions. Otherwise,
continue with Step 5.
Step 5
Align a cable-management bracket (3) to the threaded holes in the front of the chassis.
Step 6
Using two M4 x 8-mm Phillips flathead screws (4), thread and tighten the screws through the cable-management
bracket and into the chassis.
Step 7
Repeat Step 5 and Step 6 on the other side of the router.
If you have an NPE-G1 or NPE-G2 installed, go to the “NPE-G1 or NPE-G2 Rear Cable-Management Brackets on a
Rear-Mounted Router” section on page 15, or the “NPE-G1 or NPE-G2 Optical Cable-Management Bracket” section on
page 16.
If you do not have an NPE-G1 or NPE-G2 installed, go to the “Two-Post or Four-Post Rack Installation” section on page 16.
1
Rack-mount bracket
3
Cable-management bracket
2
M4 x 8-mm Phillips flathead screws
4
M4 x 8-mm Phillips flathead screws
53500
2
ETHERNET-10BFL
E
N
R
X
0
1
2
3
4
TX
R
X
TX
R
X
TX
R
X
TX
R
X
TX
ETHERNET 10BT
EN
A
B
LE
D
0
2
1
3
LIN
K
0
1
2
3
0
4
1
3
5
6
FAST SERIAL
EN
TD
TC
R
D
R
C
LB C
D
TD
TC
R
D
R
C
LB
C
D
TD
TC
R
D
R
C
LB C
D
TD
TC
R
D
R
C
LB C
D
EN
A
B
LE
D
MII
LINK
RJ45
FAST ETHERNET
0
TOKEN RING
0
1
2
3
ENABLED
IN-RING
4/16 Mbps
Cisco 7200
Series
FAST ETHERNET INPUT/OUTPUT CONTROLLER
ENABLED
PCMCIA
EJECT
SLOT 0
FE
ENABLEFE LINK
CPU RESET 1O POWER
OK
SLOT 1
FE MII
1
2
3
4