Cisco 7200 VXR - Manual (Page 14)

14
Figure 8 Attaching the Rack-Mount Brackets to the Rear of the Chassis—Front Recessed
Brackets Rear-Mounted—Front Recessed in the Rack
Step 1 Locate the threaded screw holes in the rear sides of the chassis.
Step 2 Align a rack-mount bracket (1) to the threaded holes in the right side of the chassis.
Step 3 Using a Number 2 Phillips screwdriver and two M4 x 8-mm Phillips flathead screws (2), attach the rack-mount bracket
to the router.
Step 4 Repeat Step 2 and Step 3 for the bracket on the other side of the router. If you are not installing cable-management
brackets, skip to the “Two-Post or Four-Post Rack Installation” section on page 16 for rack-mount instructions.
Otherwise continue with Step 5.
Step 5 Align a cable-management bracket (3) to the threaded holes in the front of the chassis.
Step 6 Using two M4 x 8-mm Phillips flathead screws (4), thread and tighten the screws through the cable-management
bracket and into the chassis.
Step 7 Repeat Step 5 and Step 6 on the other side of the router.
If you have an NPE-G1 or NPE-G2 installed, go to the “NPE-G1 or NPE-G2 Rear Cable-Management Brackets on a
Rear-Mounted Router” section on page 15, or the “NPE-G1 or NPE-G2 Optical Cable-Management Bracket” section on
page 16.
If you do not have an NPE-G1 installed, go to the “Two-Post or Four-Post Rack Installation” section on page 16.
1 Rack-mount bracket 3 Cable-management bracket
2 M4 x 8-mm Phillips flathead screws 4 M4 x 8-mm Phillips flathead screws
57003
2 ETHERNET-10BFL EN RX 0 1 2 3 4 TX RX TX RX TX RX TX RX TX
ETHERNET 10BT
EN A B LE D
0 2
1 3 LIN K 0 1 2 3
0
4
1
3
5
6
FAST SERIAL EN TD TC RD RC LB CD TD TC R D RC LB CD TD TC RD RC LB CD TD TC RD RC LB C D
ENABLED MII LINK RJ45
FAST ETHERNET
0
TOKEN RING
0 1 2 3 EN ABLE D
IN -R IN G
4/1 6 M bps
Cisco 7200
Series
FAST ETHERNET INPUT/OUTPUT CONTROLLER
ENABLED PCMCIA EJECT SLOT 0
FE
ENABLEFE LINK CPU RESET 1O POWER OK
SLOT 1 FE MII
1
2
3
4