Cisco 7200 VXR User Manual
Page 38
38
Note
If you have difficulty installing a processing engine or I/O controller in the lowest slot of a Cisco 7200 VXR
router that is rack-mounted, remove the port adapters, processing engine and I/O controller from the chassis
and reinstall them. Install the processing engine and I/O controller in the lowest slots first, then populate the
slots above them, in a bottom-to-top order.
Step 5
Insert the I/O controller and tighten the captive installation screws.
Step 6
Connect any I/O controller cables.
Step 7
Connect the router to the power source and power on the router.
Step 8
Retrieve and restore the configuration from the TFTP server and copy it to NVRAM. Use the copy tftp running-config
command to copy the saved configuration from the TFTP file server.
Step 9
Enter the show running-config command to display the currently running configuration on the terminal. Review the
display and ensure that the configuration information is complete and correct.
Step 10
When you have verified that the currently running configuration is correct, enter the copy running-config startup-config
command to save the retrieved configuration in NVRAM. Otherwise, the new configuration will be lost.
See the
publication at:
http://www.cisco.com/en/US/docs/routers/7200/install_and_upgrade/7200_i.o_controller_install/4447io.html
Replace the PC Card, Flash Memory Card, Flash Disk, CompactFlash Disk, or USB
Token
Figure 20
Replacing the PC Card, Flash Memory Card, Flash Disk, or CompactFlash Disk
Note
PC Cards or Flash memory cards, Flash Disks, and CompactFlash Disks are replaceable while the system is operating.
Step 1
Remove the PC Card or Flash memory card, CompactFlash disk or Flash Disk by pushing the ejector button (3).
Step 2
Insert the new PC Card or Flash memory card, Flash Disk, or CompactFlash Disk (1 and 2). The PC Card or Flash
memory card or Flash Disk protrudes from the I/O controller when it is completely inserted.
1
Insert the PC Card or Flash memory card, CompactFlash
Disk or Flash Disk
3
Press the ejector button
2
Insertion complete—PC Card or Flash memory card,
CompactFlash Disk or Flash Disk protrudes
EJECT
SLOT 0
57016
EJECT
SLOT 1
ENABLED
SLOT 0
SLOT 1
ENABLED
EJECT
SLOT 1
SLOT 0
ENABLED
1
2
3