Cisco 7200 VXR - Manual (Page 40)

40
Replace the SFP–NPE-G2
Figure 22 Inserting an SFP Module into the NPE-G2 Gigabit Ethernet Port 0/1
Use the following procedure to install an SFP module in the NPE-G2:
Step 1 Attach an ESD-preventive wrist strap between you and an unpainted chassis surface.
Step 2 Locate the label on the SFP module and turn the SFP module so the label is on top and the alignment groove is down.
Note The SFP module is keyed so that it cannot be inserted incorrectly.
Step 3 Insert the SFP module into SFP port 0/1, 0/2, or 0/3. The SFP module snaps into place when you have completely and
properly inserted it.
Step 4 Repeat Step 2 if you are inserting a second or third SFP module.
Installing a USB Flash Memory Module or eToken—NPE-G2
Figure 23 Connecting a USB Flash Memory Module to a Router USB Port
1 SFP port 0/1 2 SFP module
RJ45
GIGABIT ETHERNET 0 / 1
EN
LINK
ACTV
RJ45
GIGABIT ETHERNET 0 / 2
EN
LINK
ACTV
149065
TX RX
EN
LINK
ACTV
2
1
138993
AUX
FE 0/2
FOR MANA
GEMENT
USE ONL
Y
USB
U
S
B
FE
LINK