GE Feb-50 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5.
System Verification
Problem? Check the following for a solution before calling our toll free
“HELP” number at 800-448-0329
The following procedure should be used to test system configuration and
identify possible system connection errors. The phone must be con
nected to the AC power supply, lines 1 and 2 must be connected to the
line 1, 2 jack, and the phone must have been programmed with an inter
com station address.
1. Press the line 1 button. The line 1 LED and speakerphone LED
should turn green and dial tone should be heard from the speaker.
2. Dial the number for line 2. A three beep call pending tone should be
heard and the LED for line 2 should rapidly flash red with the ring
signal. If the LED for line 2 does not flash then line 2 is improperly
connected to the phone.
3. If your configuration utilizes line 3 and/or line 4, repeat steps 1 and 2
substituting the respective phone number(s) in step 2.