GE Feb-50 - Manual (Page 9)

E. Connect a LONG TELEPHONE LINE CORD to the
jack on the back of the telephone labelled LINE 3-4.
Connect the other end to wall jack(s) labelled 3 & 4 \n
the same manner described above.
F. Connect either end of the COILED CORD to the jack
on the side of the TELEPHONE BASE UNIT. Connect
the other end to the jack in the HANDSET. Place the
HANDSET in the cradle.
G. Plug the AC POWER SUPPLY CORD into the jack on
the telephone labelled DC 9V. Thread the cord behind the
STRAIN RELIEF. Plug the AC POWER SUPPLY into
the nearest electrical outlet.
H. After you plug in the AC POWER SUPPLY you should
see the INTERCOM LED flash red and green.
Consult the WORKSHEET above to see which Station
Number you have assigned to this telephone. Press
that same number on the MEMORY/INTERCOM IN­
DEX. The phone will beep, and the LED will start
flashing red as it checks to see if this station address
is already in use. If this station address is not already
in use, the LED will turn off and the telephone will
automatically conduct a “line check”. During the “line
check” the line LED’s for each line connected will
turn green. After a few seconds all LEDs will go off
and you will here 3 beeps and the telephone should
be fully functional.
NOTE: If you hear an error tone, the intercom number
you pressed has already been assigned to another
station or the TELEPHONE LINE CORDS are not pro­
perly connected. Check the LINE CORD connections.
Check the station number assignments on your
worksheet and repeat the procedure. (If you need to
change the address of a station, refer to page 28 in
the Use and Care Guide)
. If you desire, you may turn off the ringer for any line
or lines at any station. Press the STORE button and
you should see a red LED for each LINE button. The
LED indicates the line is active and will ring. To
disable a ringer press these buttons in the sequence
to the right:
The LED should turn off, indicating a disabled ringer.
Repeat this sequence for each ringer you wish to
disable.
To turn a ringer back on: See page 23 of the
accompanying USE AND CARE GUIDE.
Note: For complete information on the programming and use of
your GE Model 2-9450 telephone, consult the accompanying USE
AND CARE GUIDE.
TO DISABLE
RINGER
1
. PRO
E«0
ha
I STOHOm
PRO