Kenmore 790.75603 - Manual (Page 7)

Conversion to Liquefied Petroleum Gas (or L.P. Gas)
This natural gas range is designed to ailow for conversion
to Liquefied Petroleum (L.P.) Gas.
Only a qualified service agent should perform the L. P.
conversion. Contact the local gas provider for conversion.
The L. P. Conversion Kit is supplied with this range and is
located on the main back of the range. The kit contains
installation instructions which must be read before and
followed carefully when installing the kit.
 WARNING Personal injury or death from electrical
shock may occur if the range is not installed by a qualified
installer or electrician.
 WARNING I To avoid serious injury, any additions,
changes or conversions required in order for this
appliance to satisfactorily meet the application needs
must be made by a qualified service agent.
Surface Cooking
Use Proper Cookware
Cookware should
have fiat bottoms that
make good contact
with the entire
surface heating
element. Check for
flatness by rotating a
ruler across the
bottom of the
cookware (See
Figure 1). Be sure to follow the
recommendations for using cookware as
shown In Figure 2.
Note: The size and type of cookware used
will influence the setting needed for best
cooking resuits.
Note: Always use an utensil for Its intended
purpose. Follow manufacturer's instructions.
Some utensils were not made to be used in
the oven or on the cooktop.
ik CAUTION Do not use griddle over
more than one burner because it could
damage your cooktop. It can also result in
exposure to carbon monoxide levels above
allowable current standards and be
hazardous to your health.
CORRECT INCORRECT
Curved and warped pan
bottoms
Pan overhangs unit by more
than one inch or 2.5 cm.
Flat bottom and straight
sides.
Tight fitting lids.
Weight of handle does not tilt
pan. Pan is well balanced.
Pan sizes match the amount
of food fo be prepared.
Made of a material that
conducts heat well.
Easy to clean.
• Flame extends beyond unit.
Figure 2
Specialty pans such as lobster pots, griddles and pressure cookers may
be used but must conform to the above recommended cookware
requirements.
Heavy handle tilts pan.
.
■
*
Cookware Material types
The cookware material determines how eveniy and quickly heat is transferred from fhe surface elemenf to the pan
bottom. The most popular materials available are:
ALUMINUM - Excellent heat conductor. Some types of food will cause it to darken (Anodized aluminum cookware
resists staining & pitting). If aluminum pans slide across the ceramic glass cooktop, they may leave metal marks which
will resemble scratches. Remove these marks immediately.
COPPER ' Excellent heat conductor but discolors easily. May leave metal marks on ceramic glass (see Aluminum
above).
STAINLESS STEEL - Slow heat conductor with uneven cooking results. Is durable, easy to clean and resists staining.
CAST IRON ' A poor heat conductor however will retain heat very well. Cooks evenly once cooking temperature is
reached. Not recommended for use on ceramic cooktops.
PORCELAIN-ENAMEL on METAL - Heating characteristics will vary depending on base material. Porcelain-enamel
coating must be smooth to avoid scratching ceramic cooktops.
GLASS - Slow heat conductor. Not recommended for ceramic cooktop surfaces because it may scratch the glass.
7