A warning – Kenmore POWER MISER 153.320661 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
A WARNING
® Before removing any access
panels or servicing the water
heater, make sure the electrical
supply to the water heater is
turned “OFF”.
• Failure to do this could result in
death, serious bodily injury, or
property damage.
1, Before beginning turn “OFF” the electric power supply to
the water heater.
2,
Turn off the water supply to the water heater at the water
Shut-off valve or wafer meter.
Attach a hose to the water heater drain valve and put the
other end in a floor drain or outdoors. Open the water heater
drain valve. Open a nearby hot water faucet which wil! relieve
pressure in the water heater and speed draining.
The water passing out of the drain valve may be extremely hot.
To avoid being scalded, make sure all connections are tight
and that the water flow is directed away from any person.
4. Remove the two screws securing the access panel, and
remove panel.
5. Remove the Insulation block and pad.
6.
Lift out the tab as shown to unclip the terminal cover from
the thermostat. The terminal cover can now be removed
from the thermostat.
7.
FIGURE 35.
Disconnect the two wires on the element and unscrew the
old element from the tank.
FIGURE 36.
20