Kenmore 790.4906 - Manual (Page 10)

The KITCHEN TIMER and FLEX CLEAN (
Setting the Clock
Setting Continuous Bake or 12 Hour Energy Saving
pads control the Continuous Bake or 12 Hour Energy Saving
features. The oven control has a factory preset built-in 12 Hour Energy Saving feature that will shut off the oven if the
oven control is left on for more than 11 hours and 59 minutes. The oven can be programmed to override this feature for
Continuous Baking.
INSTRUCTIONS
To set the control for Continuous Bake or 12 Hour
Energy Saving features
1. Press and hold for 7 seconds (Figure 1). After 7 seconds
ON/OFF
"Off 12Hr Off will appear in the display (Figure 2).
2. Press to switch between the 12 Hour Energy Saving and
continuous bake features. Note: "On 12Hr On" (Figure 3) in the
display indicates the control is set for
the 12 Hour Energy
Saving mode and "Off 12Hr Off" indicates the control is set for
the Continuous Bake feature (Figure 2).
3. Press or and wait 5 seconds to accept the change.
(Figure 4; display will return to time of day).
Setting Kitchen Timer
PRESS DISPLAY
/MilTCHE^
for 7 Figure 1
seconds
0 F f"
1
Figure 2
lililí iSispi*
n „
u n
Figure 3
rnmmmmmmsmsm
ori^
Figure 4
The KITCHEN TIMER yiMERy pad controls the Kitchen Timerfeature. The Kitchen Timer serves as an extra timerin the kitchen
OW/OFF
that will beep when the set time has run out. It does not start or stop cooking. The Kitchen Timerfeature can be used during
any of
the other oven control functions. Refer to “Minumum and Maximum Control Pad Settings” for time amount settings.
INSTRUCTIONS
To set the Kitchen Timer (example: 5 minutes)
PRESS
fKiTCHEN
1 . Press "0:00" will appear and "TIMER" will flash in the
O n /O ff
display (Figure 5).
2. Press the number pads to set the desired time in the display
(example (^5^) Press The time will begin to count down
with "5:00" and "TIMER" will stay in the display (Figure 6). Note: If
CD< 3 ’
DISPLAY
n n n u-uu
Figure 5
5 -nn
■ u u
Figure 6
Figure 7
is not pressed the timer will return to the time of day.
3. When the set time has run out, ":00" and "TIMER" will show in the
display (Figure 7). The clock will beep until is pressed.
ON/OFF 'JWUff
To cancel the Kitchen Timer before the set time has run out
Press twice until the clock displays ":0:00" and "TIMER". The display will return to the time of day.
ON/OFF
To Set Add 1 Minute Feature
The ADD 1 MINUTE pad is used to set the Add 1 Minute feature. When the pad is pressed, 1 minute is
added to the Minute Timer feature if this feature is already active. If the Minute Timer feature is not active and the
pad is pressed, the Minute Timer feature will become active and will begin counting down from 1 minute. For further
information on how to set the Minute Timer feature see To Set the Minute Timer instructions above.
10