Self-cleaning, What to expect during cleaning, To start the self-clean cycle – Kenmore 790.4906 User Manual

Page 26: Â caution, Instructions, Press, Ik caution, Display, When the self-clean cycle is completed, Stopping or interrupting a self-cleaning cycle

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Self-Cleaning

What to Expect during Cleaning

While the oven is in operation, the oven heats to temperatures much higher than
those used in normal cooking. Sounds of metal expansion and contraction are
normal. Odor is also normal as the food soil is being removed. Smoke may appear
through the oven vent.

If heavy spillovers are not wiped up before cleaning, they may flame and cause more
smoke and odor than usual. This is normal and safe and should not cause alarm. If

available, use an exhaust fan during the self-cleaning cycle.

To Start the Self-Clean Cycle

NOTE:

A smoke eliminator in the

oven vent converts most of the
soil into a colorless vapor.

 CAUTION

To avoid possible

burns use care when opening the
oven door after the Self-Cleaning
cycle. Stand to the side of the oven
when opening the door to allow hot
air or steam to escape.

DO NOT

force the

The FLEX CLEAN

pad controls the Self-Cleaning feature. If you are planning

to use the oven directly after a self-clean cycle remember to allow time for the oven
to cool down and the oven door to unlock. This normally takes about one hour. So a
3 hour self-clean cycle will actually take about 4 hours to complete.
*lt is recommend to use a 2 hour self-clean cycle for light soils, a 3 hour cycle for
average soils,

and a 4 hour cycle for heavy soils (to assure satisfactory results).

INSTRUCTIONS

To

set

the controls

for

a 3 hour Self-Cleaning cycle

to

start immediately and shut off automatically

1. Be sure the clock is set with the correct time of day and the oven

door is closed.

2

.

PRESS

ik CAUTION

oven door open. This can damage
the automatic door locking system.

Use caution and avoid possible

burns when opening the door after
the

Self-Cleaning

cycle

has

completed. The oven may still be
VERY HOT.

DISPLAY

Press (^¡) . "CLEAN", "1" and "TIME " will flash in the display

(Figure 1). The control will automatically clean for a 3 hour period
(default self-cleaning cycle time). Note: If a 2 or4 hour clean time

is desired, press

CD Co)®

for 2 hour or press ®

®®®"

®®

for

a

4

hour

clean

time.

Set

the

cleaning

time

based

®®®

on the amount of soil: light, medium or heavy (* See above).

3. PressCSTARy .The "OVEN"oncethedoorhaslocked, "CLEAN",

"LOCK" and "jONl" will appear in the display (Figure 3).

4. When flex clean finishes, lock will remain in the display until the

door has unlocked and "END" will appear (Figure 4)

Note: Allow about 15 seconds for the oven door lock to close.

When

the

Self-Clean Cycle is Completed

1. The time of day and "END " will remain in the display (Figure 4).

2. Once the oven has cooled down for approximately 1 HOUR, and

""END"

is no longer displayed, the oven door can then be opened

(Figure 5).

Stopping or Interrupting a Self-Cleaning Cycle

If it becomes necessary to stop or interrupt a self-cleaning cycle due

to excessive smoke or fire in the oven:

1. Press I

2. The oven door can only be opened after the oven has cooled down

for approximately 1 HOUR, and " END" is no longer displayed
(Figures).

Figure 1

3

"" ■■nr)::

Figure 2

■3

J *uu

Figure 3

E n d

Figure 4

Figure 5

26

Advertising