1 press open to open the front panel, 3 press a or t to turn flap auto on or off, 2 press function to select aux – Pioneer SUPER TUNERIII DEH-P8500MP User Manual
Page 41: 3 press a or t to turn aux on or off, Aux:on) a, 2 press function to select dimmer, 3 press a or t to turn dimmer on or off, 3 press ◄ or ► to adjust the brightness ievel, Initial settings, 5switching the flap auto open
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Initial Settings
Section
5
Switching the flap auto open
For theft protection, the front panel opens
automatically and easily detaches. Flap auto
open Is on as a default.
1 Press OPEN to open the front panel.
2 Press FUNCTION to select Flap Auto.
Press
FUNCTION
repeatedly until
Flap Auto
appears in the display.
3 Press A or T to turn Flap Auto on or
off.
Pressing
A
or
T
will turn
Flap Auto
on or off
and that status will be displayed (e.g.,
Flap Auto:ON).S
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press OPEN to open the front panel.
2 Press FUNCTION to select AUX.
Press
FUNCTION
repeatedly until
AUX
ap
pears in the display.
3
Press A or T to turn AUX on or off.
Pressing
A
or
T
will turn
AUX
on or off and
that status will be displayed (e.g.,
AUX:ON) a
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car's headlights are turned on. You
can switch dimmer on or off.
1 Press OPEN to open the front panel.
2 Press FUNCTION to select Dimmer.
Press
FUNCTION
repeatedly until
Dimmer
ap
pears in the display.
3
Press A or T to turn Dimmer on or off.
Pressing
A
or
T
will turn
Dimmer
on or off
and that status will be displayed (e.g..
Dimmer ;ON). a
Adjusting the brightness
You can adjust the display brightness. Initially
this mode is set to
12
.
1 Press OPEN to open the front panel.
2
Press FUNCTION to select Brightness.
Press
FUNCTION
repeatedly until
Brightness
appears in the display.
3 Press ◄ or ► to adjust the brightness
ievel.
Each press of or ► increases or decreases
the brightness level.
0 -15
is displayed as the
level is increased or decreased, a
Setting the rear output and
subwoofer controller
This unit’s rear output (rear speaker leads out
put and RCA rear output) can be used for full-
range speaker
(Rear SP:FULL)
or subwoofer
(Rear SP:S.W)
connection. If you switch the
rear output setting to the
Rear SP:S.W,
you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
m
3
to.
w
En