Winding the bobbin (continued), Lower threading – Brother X L 2010 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Lower threading
Winding the bobbin (CONTINUED)
Holding the thread end, de
press the foot controller to
wind the thread.
The machine stops automati
cally when the bobbin is full.
S. Push the shaft to the left.
Remove the full bobbin from
the shaft, and trim the excess
thread.
Tighten
the
clutch
release
knob securely.
Unwind about 4 inches (10
cm( from the bobbin, and
insert
the
bobbin
into
the
bobbin case. Pull the trailing
thread into the slot, down
and to the left until it enters
the delivery eye under the
tension spring.
Holding
the
bobbin
case
latch, insert the bobbin into
the shuttle race. Make sure to
fit the metal finger into the
notch at the top of race.
8