Brother P-TOUCH PC - Manual (Page 16)

Software
Printing Print type:
Print condition: Bit image only
Auto tape cut: ON / OFF
Left and right margins: small, medium, large, none
Buffer *Print buffer (normal): Approximately 30KB (27 cm)
**Reception buffer; 512B
Transmission Baud rate; 9600 (fixed); data reception at 9600 bps
control Busy output: Xon/off and DTR
Length: 8 bits (fixed)
Parity: none (fixed)
Commands CR Carriage return
LF Line feed
FF Print command
CTRL-Z Print command with feed
ETX Same as CTRL-Z
ESC J Line feed
ESC$ Absolute position assignment
ESC\ Relative position assignment
ESC* ** Bit image selection
ESC@ Initialization
E S C i S Status request
E S C i M Mode specification
E S C i D Print density control
E S C i P Printing command for continuous page
Others Tape cut ON / OFF
Tape end detection
Cutter error detection
Tape type / Tape detection (with or without)
*Print buffer: stores the print image that is printed by the thermal head
**Reception buffer: stores a received interface data temporarily until it is sent to the print
buffer
1 3