Sharp R270SLM - Manual (Page 6)

INSTALLATION
5^
A
WARNING:
Inspect the Oven:
Check the oven carefully for damage
before and regularly after installation.
Make sure the door closes properly,
that it is not misaligned or warped.
Check the hinges and door safety
latches are not broken or loose.
Ensure the door seal and sealing
surfaces are not damaged. If the door
or door seals are damaged, the oven
must not be operated until it has been
repaired by a competent person.
Inspect the oven interior and door for
dents.
IMPORTANT:
If any damage is apparent, do not
operate the oven in any way, until it
has been repaired by a SHARP trained
engineer.
1. Remove ail packing materials including the
feature sticker (if applicable). Do not remove
the plastic film from the inside of the oven
window as this protects it from dirt.The
waveguide cover prevents food and grease
from entering the waveguide area where it
could cause damage. DO NOT REMOVE
THE WAVEGUIDE COVER.
2. Place oven on a secure, level surface.
Ensure it is strong enough to take the oven
weight, plus the heaviest item likely to be
cooked in the oven.
3. The minimum
height of free
] 15cm
• t #
space necessary
above the top
surface of the oven
is 15cm.
Do not place the oven where heat, moisture
or high humidity are generated, (for example,
near or above a conventional oven) or near
combustible materials (for example, curtains).
Do not block or obstruct air vent openings.
Do not place objects on top of the oven.
5. Make sure the power supply cord
is undamaged (See “ELECTRICAL
CONNECTION” below).
Do not allow the power supply cord to
run over any hot or sharp surfaces, such
as the hot air vent area at the top rear
of the oven.
6. The socket must be readily accessible so that
it can be easily unplugged in an emergency.
7. Do not use the oven outdoors.
BUILDING-IN-KIT.
No built-in kit is available for this oven.
This oven is designed to be used on a countertop
only.
ELECTRICAL CONNECTION.
♦ Do not allow water to come into contact with
the power supply cord or plug.
» Insert the plug properly into the socket.
♦ Do not connect other appliances to the same
socket using an adaptor plug.
♦ If the power supply cord is damaged, it must be
replaced by a Sharp approved service facility or
a similarly qualified person to avoid a hazard.
♦ When removing the plug from the socket
always grip the plug, never the cord as this
may damage the power supply cord and the
connections inside the plug.
♦ If the plug fitted to your oven is a rewireable
type and in the event of the socket outlet in
your home not being compatible with the plug
supplied, remove the plug properly (do not cut
off).
♦ If the plug fitted to your oven is a non-rewirabie
type and in the event of the socket outlet in
your home not being compatible with the plug
supplied, cut-off the mains plug.
♦ Refit with a suitable type, observing the wiring
code given in To replace the mains plug’ on
page 24.
R-269[cover-28].indd 4 7/23/08 11:57:51 AM