Compaq MP2800 - Manual (Page 11)

Getting Started 11
Part Number: 216023-001 - Writer: Carey Gregg - Saved by: The Integrity Group
Pages: 18 Words: 2766 Saved date: 09/22/0010:37 AM File Name: Ch01.doc
4. Press the blue Standby button on the top of the projector to turn on the
projector first, then turn on the computer.
✎ For security purposes, this projector has been fitted with a
security lock slot ➌ (located on the left, front side) for use
with a security cable lock that can be purchased separately at
most computer stores.
Connecting the Projector to a Compaq PC Companion
To connect the projector to a Compaq PC Companion, the PC
Companion must have a male connector adapter and a VGA-out PC
Card with a 15-pin connector.
✎
The VGA-out PC Card with the 15-pin connector is not
included with the Compaq PC Companion. It is sold
separately. For information on purchasing this card, call your
Compaq authorized dealer or reseller. To locate a reseller near
you, check the “Worldwide Telephone Numbers” booklet that
came with your projector or visit the Compaq website at
http://www.compaq.com
.
1. Rotate the elevator foot to balance the projector.
2. Connect one end of the signal cable
➊ to the projector and
connect the other end to the VGA-out PC Card. The VGA-out
PC Card may be inserted into the PC slot on the Compaq PC
Companion before or after connecting the signal cable.
✎ Be sure the signal cable aligns with the connector. Do not
force the cable onto the connector or you may damage the
signal cable or the projector.