Confirming stored dtmf numbers, Transmining stored dtmf numbers, Transmitting stored dtmf numbers – Kenwood TM-261A User Manual
Page 47: M i . m
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6
Press a single key [0] - [9] to select a DTMF memory
channel.
• The selected memofy channel number appears and stays
for approximately 1 second, then the display for entering
DTMF numbers is restored.
7
Press [VFO] to restore the Menu B Scroll display, or
wait for several seconds to restore the frequency
display.
CONFIRMING STORED DTMF NUMBERS
1 Press [F]+ POWER ON to access Menu B.
2 Select “DTMF.CK” {page 17}.
3
Press [VFO].
• The display for confirming DTMF numbers appears.
Press a single key [0] ~ [9] to select a DTMF memory
channel.
•
The entered memory channel number appears and stays
for approximately 1 second, then the numbers stored in
the channel scroll across the Display.
•
The corresponding DTMF tones are output from the
speaker.
•
After the scrolling is completed, the display for confirming
DTMF numbers is restored.
5 Press [VFO] to restore the Menu B Scroll display, or
wait for several seconds to restore the frequency
display.
TRANSMiniNG STORED DTMF NUMBERS
To transmit a stored DTMF number, follow the procedure
below.
1
Press microphone
[PTT]+[PF].
• The display for selecting a DTMF memory channel
appears.
U T
C A//
M i . M
MHz
V_____
-s---------7--------9-------- OVER
TONE
REV
2 Press a single key [0] ~ [9] to select a DTMF memory
channel.
•
The number stored in the memory channel scrolls across
the Display accompanied by DTMF tones from the
speaker.
•
After the transmission, the frequency display is restored.
•
If a memory channel that does not contain DTMF numbers
is selected, an error beep sounds.
•
To escape from this DTMF memory channel mode, press
microphone
[PTT]
again instead of a single key
[0] - [9].
The frequency display is restored.
[10
41