Installing the tsu-8 ctcss unit, Installing options – Kenwood TM-261A User Manual
Page 60
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
INSTALLING THE TSU-8 CTCSS UNIT
CAUTION:
Always switch OFF the power and unplug the DC power
cable first.
1 Remove the two screws from the upper cover of the
transceiver.
INSTALLING OPTIONS
Hold the TSU-8 unit with the large 1C facing downward,
and insert the connector on the TSU-8 unit into the 8-pin
connector as shown. Take care to keep the TSU-8
horizontal when inserting it into the 8-pin connector.
Crystal
2 Remove the upper cover.
Large 1C facing down
4 Replace the upper cover and screws.
.
15]
54
Advertising
This manual is related to the following products: