Fluke 2180A - Manual (Page 52)

2180A
600-7. DIVIDER, THERMOMETER
CALIBRATION (Y2022)
600-8. The device is a preset 100 to 1 divider to provide
the precision millivolt outputs from a DC Calibrator
required for calibration. The device wires into the RTD
Input PCB in place of the RTD Probe during calibration.
Refer to the Y2022 Instruction manual for the schematic
and additional information.
600-9. RACK PANELS
600-10. Available are rack mounting panels in three
sizes and two types for the standard 19-inch electronics
equipment racks. The "A" size for the Multipoint Selector
is available in panels that will accomodate either one or
two instruments. The "B" size panel for the Calibrator
and/or Battery Pack is also available for single or double
instruments, as is the "C" size used for the 2180A
Thermometer and the Alarms Output.
600-11. PANEL MOUNTS
600-12. The panel mounts provide the hardware to
install the instrument in any panel in which a hole the size
of the instrument front panel can be cut. It is available for
the three instrument sizes required, "A", "B", and "C".
600-13. POWER CORD, 3-WAY (Y2024)
600-14. This accessory is a specially constructed power
cord with three female and one male connectors that
allow the operator to connect up to "C" size or smaller
PTI instruments with one line power cord.
600-15. CABLE OUTPUT UNITS,
RS232C (Y2026B)
600-16. The Y2026B is an interface device which allows
direct mating between any RS232C device and the -002
Output Option. The Y2026B consists of two 25-pin
connectors, one 36-pin connector, and an accessory cable
to connection between the 36-pin output and the -002
Output Option. It will be necessary for the user to provide
the cable between the 25-pin outputs and the RS232C
devices.
600-2