Kenwood Preset Remote Control - Manual (Page 14)

In case of difficulty
Mi
Remote control unit
Cause , 1 Remedy
The battery indicator flashes during opera­
tion. > The batteries are nearing exhaustion. ® Replace with new batteries to presen/e the
currently registered setup information.
Subwoofer volume cannot be adjusted. « Subwoofer is OFF. “ Turn the subwoofer ON. -OS
Certain inputs cannot be selected using the
remote control. ® No setup codes registered at for the respective
input(s).
«Register a setup code or Non-IR code at the
respective input(s). RC-C33
Remote control operation is not posstbie. * The remote control is set to a different operation
mode.
“ Batteries are exhausted.
» The remote control unit is too far away from the
main system, controiting angle is too large, or
there is an obstacle between the receiver and
the remote.
* The audio cords and system control cords are
not connected properly.
» No software is loaded in the source component.
® An attempt is made to play a tape which is being
recorded in the cassette deck.
* The remote control has not been set to the
operation mode for the component you wish to
control.
e The microprocessor of the remote control mal­
functions.
® Press the MUSIC, MOVIE, or TV keys to select
the appropriate operation mode,
" Replace witii new batteries,
o Operate the remote control unit within the con­
trollable range.
‘ Connect properly referring to "Setting up the
system".
® Place software in the source component you
want to play,
® Wait until recording has completed.
* Press the MUSIC, MOVIE, or TV keys to acti­
vate the operation mode for the component you
want to control before operation. RC-CC3
• Reset the microprocessor.
»i