Restoring the original factory – Kenwood Preset Remote Control User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
© Press the
a
/
t
keys to select the location.
1
Bitei-idl “ E-;rtend5 are available.
© Press the {Enter] key.
« The remote contro! is ready for receiving the remote control code.
B-'cti'endi
IClr Exit
J
® Press the key of the same operation that you want to store.
• The remote code is send to the remote control unit,
o ‘’CoMP-lete" appears when finished.
r
Cortiplelí'
Ext Sfidi
V.
__
)
Restoring the original factory
iS l l
.......... .......................................... ....................................
You can restore the setup codes or memories to their original default
settings
* When it takes for more tharr 8 seconds or the remote control unit does
not receive the remote control code we)!,
appears in the
display. In this case, re-operate from the step ©,
• "Full" appears when the mOTtory is full. Re-operate from the step
® after deleting some memories.
© The remote control code is stored on the memory {Extendi -
Extends) of the remote control unit.
Insert the batteries during pressing and holding the
[
a
]
keys and key,
* "Cleared" appears in the display, and the remote settings return to
their original default settings.
To delete the stored memory
Press the [Clr] key in step
©. ’'Cleared"
appears in the display
and the memory that is selected in step © is erased.
To operate other components by using the stared memory
0 Press the MUSIC, MOVIE, or TV key to select desired Input
source.
• The Menu display appears.
® Press the {Menu] key .
© Press the
a
/
t
keys to select the memory you want to operate.
© Press the [Enter] key.