Uniden UH-088 - Manual (Page 18)

Channel Seeking Operation
Unlike normal scanning, CHANNEL SEEK is used more often when checking for
active channels.
If a signal is detected, while seeking, the UH-088 will tune to that signal for 4 seconds
only and then resumes Seeking Operation.
Changing from SCAN to SEEK Mode operation.
1. Firstly, activate SCAN mode.
HTIJOO h
Zi
c
jfO
2. Press and hold SCAN until a "beep" is heard. The
SCN icon starts to flash. \ < o o
u
3. If an active channel is detected the UH-088 will stop
on that channel for 4 seconds, (eg. CH17)
I>f(
/
I I
4. After 4 seconds, the UH-088 will start seeking again
for active channels.
^ u u
5. If you find the channel interesting, simply press either
the PTT switch or the SCAN key to stop the operation
before the 4 second timer elapses.
03 ^ |*Y
msjBSOuH. f LJ
When SCAN is pressed again SEEK is still the mode of operation.
To change back to SCAN, while SEEKING, press and hold
SCAN until a beep is heard. The SCN icon stops flashing.
o
o
L I U
Note: SEEK checks the same channel stored in SCAN memory. Thus, you can Seek
either in OS or GS Mode.
17