Selective calling – Uniden UH-088 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Selective Calling
When you listen to UHF CB, you will hear all the conversations going on, which can
become annoying at times. Ideally you need a system that alerts you when the signal
is from someone you wish to communicate with.
>ou want your radio to be SELECTIVE about the people you talk tol
SELECTIVE CALLING is a special Squelch System which quiets your receiver unit
until it receives an encoded signal from another set which matches the one installed in
your set.
This means your set will remain quiet until the station you want to hear calls.
Note: • SELCALL is not initially installed in your set (each has to be individually
programmed), but may be purchased as an option.
• When you install SELCALL option, you should cut the Jumper wire (W1)
inside the UH-088.
18